Subaru B9 Trifecta SUV Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
50 Posts
Discussion Starter · #1 ·
I purchased a drawtite class II hitch and I know it is bolt on, my question is where is the wiring on an 08 for the wiring harness? Thanks in advance!
 

·
Registered
Joined
·
65 Posts
Most of the changes are cosmetic and in the drivetrain, so it may be in the same location as the '06s and up. If that is the case, it is located in cabin, by the driver's side rear end of the wheel jack tray. Take the cover off, take all of the stuff out of the tray, pull the (4) plastic panel stays out (make sure to keep them as you will reuse them), and remove the tray. Look underneath the ledge on the drivers side for an unused plug. If it matches what you bought, plug it in, tape the box down, and ziptie the wire in.

You can route the rest where ever you feel works for you. I popped a hole in the tray and leave it coiled in there until needed, where I just pull it out and close the hatch over it.
 
1 - 2 of 2 Posts
Top