Joined
·
449 Posts
Front Bumper Underguard install page
1 - 1 of 1 Posts
1 - 1 of 1 Posts
Join the discussion
Recommended Reading
-
Exterior / StylingHi everyone - wondering if anyone has installed LED H7 headlight bulbs. I have an 06 B9. I searched the forum but haven't seen anyone post anything about LED headlights. Is it even possible in the MY06's with the clips and caps? Maybe that's why it's not posted here anywhere. Any help...
- 61
- 10K
-
Exterior / StylingHey everyone, I'm currently trying to replace the radiator on my 2006 B9 Tribeca and so I'm trying to get the old one out. I'm at the step where I need to remove the front bumper in order to get to the bolts that hold the AC condensor to the radiator. So I was following the service manual but...
- 3
- 3K
-
Exterior / StylingHello! Trunk hatch wont open on my tribeca anymore. It does not to anything anymore actually. Where to start looking for a problem? Help needed!
- 21
- 976
-
SubaruTribeca · updated
-
Exterior / StylingHello everybody. I hope everybody is okey in this times. Start replacing low beam bulb and find out that small screw which holding cover in place get bad. Head become rusty and round , can't fit screwdriver. Any ideas what types, kind of screw I can use. Try to look online to buy screw...
- 13
- 298
-
Exterior / StylingHello All, Has anyone done a front end conversion from the B9 to the current front end\facelift model yet? Are the parts inter change able? Front guards, bonnet front grille, bumper? I'm thinking of updating my B9.
- 19
- 4K
Join now to ask and comment!