Subaru B9 Trifecta SUV Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter #1 (Edited)
Was chasing a “clunk” sound from the rear end and it appears all of the bushings on the rear knuckles (both sides) are past their useful life.. the car just recently turned 200k miles so I’m not too surprised. The rear control arms are a little sloppy too but the bushings in the knuckle are real bad...
I’ve recently done all 4 corners for struts/shocks (including top mounts/bushings), front control arm assemblies, sway bar bushings (fronts were shot but rears were in pretty good shape).

Question(s):
Has anyone done a rear knuckle bushing replacement?
Are these bushings pressed in (metal sleeved) or just rubber inserts into the knuckle?
Has anyone seen a DIY post for this? I searched but I don’t see anything for the Tribeca.

Thanks for any help.
 
1 - 1 of 1 Posts
Top