Recently had a misfire code on cylinder 1 and traced it back to a problem with the ECM board on my 2007 B9 Tribecca. Found wiring diagrams to the ECM Board plugs but wondering if there is a diagram of the board itself? I must have a hairline break in one of the circuits because I can push done...

I need help repairing my 2006 Subaru B9 Tribeca. It lost power while driving several months ago. It has 256,000 miles on it. After a tow, mechanic said it has good oil and gas pressure and is likely an electrical issue. The engine turns over, but does not start. Mechanic estimated 1-2...

So I have a project being built from a 2006 B9 Tribeca Tad @ DSS has agreed to make me a one piece aluminum 3"OD drive shaft and high torque rear axles The vehicle is being prepared to be shipped to my location but I want to get these made so timing is same. I need the measured distance on...

Looking to do a fuel pressure test. 2008 3.6. The FSM does not have a very good diagram as to which line to disconnect--but I think it's this one? Also, it appears you need some sort of Subaru specific tool to disconnect the lines? Can anyone share some details and what you need or how...

Hi Tribeca Community- We have had our 08 Premier for a a few months, I have done some significant work (pulleys/full suspension/some hoses and most fluids). We noticed that whenever it has been running at freeway speeds for about 90 minutes we are a P0174 (lean condition, bank 2). It runs...