PDA

View Full Version : Tranny fluid drain and fill


Roccobon
04-02-2010, 02:44 PM
I'm gonna attempted this when it gets warm. How many liters will I need? Also has anyone changed the filter and do you really have to take off the front bumper?

estampidate
04-03-2010, 11:34 AM
My dealer did it and charge me 4 quarters. It is because not all fluid can come out (it remains 3 quaters more)

abp05gt
12-03-2010, 03:51 PM
Fluid capacity
(US qt, Imp qt)
9.6 — 10.0 (10.1 — 10.6, 8.4 — 8.8)
straight from the service manual

tribecadean
12-07-2010, 08:36 PM
any one do this theirself...I want to do this.

I heard it take a special fluid and additive

milo066
02-10-2011, 07:56 PM
ATF Filter
AUTOMATIC TRANSMISSION


18.ATF Filter


A: REMOVAL


1) Remove the front bumper. <Ref. to EI-21, REMOVAL,

Front Bumper.>
2) Using the ST, remove the ATF filter.
ST 498545400 OIL FILTER WRENCH

B: INSTALLATION


1) Apply a thin coat of ATF to the oil seal part of

new ATF filter.
2) Install the ATF filter. Turn it by hand, being careful
not to damage oil seal.
3) Tighten the ATF filter using ST.
Calculate the ATF filter tightening torque using following
formula.
T2 = L2/(L1 + L2) × T1
T1: 14 N·m (1.4 kgf-m, 10.1 ft-lb)
[Required torque setting]
T2: Tightening torque
L1: ST length 78 mm (3.07 in)
L2: Torque wrench length
Example:
NOTE:
Align the ST with the torque wrench while tightening
the ATF filter.
ST 498545400 OIL FILTER WRENCH
4) Fill ATF.
5) Inspect the level of ATF. <Ref. to 5AT-26, Automatic
Transmission Fluid.>
6) Install the front bumper. <Ref. to EI-22, INSTALLATION,
Front Bumper.>

C: INSPECTION


Check for rust, hole, ATF leaks or other damage.

Replace the part if any damage is found in the inspection.

Torque wrench length

mm (in)
Tightening torque
N·m (kgf-m, ft-lb)
100 (3.94) 7.7 (0.79, 5.7)
150 (5.91) 9.0 (0.92, 6.7)
200 (7.87) 10 (1.0, 7.4)
AT-03251

milo066
02-10-2011, 07:59 PM
It would be interesting to hear from someone that actually changed the filter and see if it can be done without removing the bumper.

relsoc
02-05-2012, 06:44 AM
I'm almost positive you can change the ATF filter by removing the drivers side headlight capsule. Once that is out the filter is right there.

Super
02-07-2012, 07:38 PM
I drained just a bit shy of 4l from my 08.